|
After my first ideas section the next logical step is to take my favourite idea through development
to a final design. I will do this development through both CAD (Truespace 4se) and sketch model (foam
board and pins) methods. These techniques will allow me to improve on my ideas and come to a final idea, which I
can produce a CAD visualization and finally a scale model of.
In this section I have used one model, changing it throughout, I have taken photos at intervals of my idea development
and grouped them into pages. Because of the low quality camera used for these interval photos I have added an overlay
wireframe mesh produced digitally. This makes the photographs clearer, and gives a better sense of what the image portrays.
I have also included a human figure cut-out to give a sense of scale.
|
 |
|
